Cabletron Systems 510 Manual De Usuario

Installing and Cabling

2-7

Plug the ac power supply cable (2) into the power supply, then 
into a wall outlet.

Upon receiving power, verify that the router’s Power LED lights 
immediately, that the Module OK LED lights within five seconds, 
and that the router performs a self-test.

Note:  The self-test requires 25 seconds to complete.

After the router completes self-test, and if the router is 
unconfigured, the Power, Module OK, and Network OK LEDs 
remain lit. The Network Activity LED blinks at a rate proportional 
to the amount of activity on the port.

Note: If the LEDs do not operate as described, refer to Appendix A. 

Connect the dedicated Ethernet T-connector (3) OR the Twisted 
Pair Connector (4):

a)  Attach the dedicated Ethernet T-connector (3) to the BNC 

network connector and turn the connector one-quarter turn 
clockwise until it locks into place. Terminate the connection 
with a 50-ohm terminator or extend the Ethernet segment to 
the next device.

To disconnect the dedicated Ethernet T-connector, turn the 
connector one-quarter turn counter-clockwise until the 
connector clears the BNC connector stem, then disconnect 
the cable.

b) OR, connect the 10BaseT cable (4) to the twisted pair 

connector (8-pin MJ Ethernet connector).

Note: Do not use both dedicated Ethernet and twisted pair 
connectors simultaneously.

Connect the ISDN cable (5) to Port 2 of the router.

Connect the serial cable (6) to Port 1 on the SSR-510 router.

Connect the console cable (7) using the 8-pin MJ connector. Use 
an H8584-AC adapter if necessary.

After successful installation and power-up, configuration 
information will display on the console monitor, including 
questions about your network topology.