Cabletron Systems 3Com Manual De Usuario
50
C
HAPTER
4: C
ONFIGURING
THE
A
CCESS
P
OINT
U
SING
A
W
EB
B
ROWSER
10 Do nothing with the RTS Threshold setting. RTS/CTS operation is not supported at
this time.
11 Click Clear Entries to reinstate the default settings.
12 Click Save Settings to save your entries on this page.
Configuring the SNMP
Agent
An SNMP manager application gains access to the AP SNMP agent if the
management application has the AP’s IP address. To ensure security when SNMP is
used, the SNMP agent can be configured as read-only, read-write, or disabled. The
AP sends specific traps for some conditions.
management application has the AP’s IP address. To ensure security when SNMP is
used, the SNMP agent can be configured as read-only, read-write, or disabled. The
AP sends specific traps for some conditions.
See the 3Com MIB on the Wireless LAN Installation and Utilities disk for
specific entries.
specific entries.
The AP supports SNMP V1, MIB-II and the 3Com.MIB. To configure the SNMP
agent, follow the procedure below.
agent, follow the procedure below.
1 Select Configuration-->SNMP.
The SNMP Setup page displays.
2 Select a mode for SNMP Agent Mode.
■
Disabled disables SNMP functions.
■
Read-only allows get and trap operations.
■
Read/Write (default) allows get, set, and trap operations.
3 Enter a user-defined password of up to 31 characters for Read-Only Community.
This password is for and identifies users with read-only privileges.
4 Enter a user-defined password of up to 13 characters for Read/Write Community.
This password is for and identifies users with read/write privileges. This password
should be the same password as the System Password used to gain access to the
System Configuration page.
should be the same password as the System Password used to gain access to the
System Configuration page.
5 Enter the IP address of the trap manager for Trap IP Address.
6 Select Enabled or Disable All for All SNMP Traps.
Use this feature to disable all traps or to selectively enable the individual traps. The
default value is Disabled. The table below explains the traps.
default value is Disabled. The table below explains the traps.
7 Click Clear Entries to reinstate the default settings.
8 Click Save Settings to save your entries on this page.
SNMP Trap
Description
Default Value
Cold Boot
Sends a trap to the manager when the
AP cold boots.
AP cold boots.
Deselected
Authentication Failure
Indicates that community strings other
than those specified for the Read-Only
and Read/Write Community were
submitted.
than those specified for the Read-Only
and Read/Write Community were
submitted.
Deselected
Radio Restart
Sends a trap to the manager for radio
restart.
restart.
Deselected
Access Control
Violation
Violation
Sends a trap to the manager when an
ACL violation occurs.
ACL violation occurs.
Deselected
DHCP Change
Deselected