Cabletron Systems NB20E Manual De Usuario

 

This section contains instructions for installing Cabletron Systems' 
NB20E or NB25E Two Port Ethernet Bridge, and for preparing the bridge 
for operation. Verify that all network design guidelines and site 
requirements listed in Chapter 2, 

 

,

 

are met before installing the bridge. 

 

Before you install the NB20E or NB25E Bridge, you should visually 
inspect the bridge and check the contents of the accessory package. To 
unpack the bridge and accessory package:

1. Carefully remove the bridge from the shipping box. Save the shipping 

box and materials in the event the unit has to be reshipped.

2. Slide the two foam end caps off of the bridge and remove the bridge 

from its protective plastic bag. Set the bridge aside to prevent the unit 
from being damaged.

3. Remove the plastic bag containing the accessory package and check 

that the bag contains the following items:

•

one 8 foot (2.44 m) power cord

•

one cable support bracket

•

two 8-32 x .375 inch screws

•

three 6 (15.24 cm) inch cable ties

•

rack mount brackets

Contact Cabletron Systems' Technical Support immediately if any 
discrepancy in materials exists.

 

After you have met all requirements listed in Chapter 2, 

 

 

 

, complete the installation instructions provided in this 

section.