Cisco Systems 1240AG Manual De Usuario
2-22
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-8371-05
Chapter 2 Installing the Access Point
Powering Up the Access Point
Connecting to an Ethernet Network with Local Power
Caution
Be careful when handling the access point; the bottom plate might be hot.
Note
If your access point is connected to in-line power, do not connect the power module to the access point.
Using two power sources on the access point might cause the access point to shut down to protect internal
components and might cause the switch to shut down the port to which the access point is connected. If
your access point shuts down, you must remove all power and reconnect only a single power source.
Using two power sources on the access point might cause the access point to shut down to protect internal
components and might cause the switch to shut down the port to which the access point is connected. If
your access point shuts down, you must remove all power and reconnect only a single power source.
Follow these steps to connect the access point to an Ethernet LAN when you are using a local power
source:
source:
Step 1
Connect a Category 5 Ethernet cable to the RJ-45 Ethernet connector labeled Ethernet on the access
point (see
point (see
).
Step 2
Step 3
Plug the other end of the Ethernet cable into an unpowered Ethernet port on your LAN network.
Step 4
Plug the other end of the power module into an approved 100- to 240-VAC outlet.
For information on securing your access point, see the
.
Powering Up the Access Point
When power is applied to the access point, it begins a routine power-up sequence that you can monitor
by observing the three LEDs on the end of the access point. After you observe all three LEDs turning
green to indicate the starting of the operating system, the Status LED blinks green signifying that the
access point is operational. After a successful power-up sequence, the Status LED turns light green to
signify that there are no client devices associated, or it turns blue to signify that there are client devices
associated. Refer to the
by observing the three LEDs on the end of the access point. After you observe all three LEDs turning
green to indicate the starting of the operating system, the Status LED blinks green signifying that the
access point is operational. After a successful power-up sequence, the Status LED turns light green to
signify that there are no client devices associated, or it turns blue to signify that there are client devices
associated. Refer to the
or the
for LED descriptions.
Caution
Be careful when handling the access point; the bottom plate might be hot.
Note
If your access point is connected to in-line power, do not connect the power module to the access point.
Using two power sources on the access point might cause the access point to shut down to protect internal
components and might cause the switch to shut down the port to which the access point is connected. If
your access point shuts down, you must remove all power and reconnect only a single power source.
Using two power sources on the access point might cause the access point to shut down to protect internal
components and might cause the switch to shut down the port to which the access point is connected. If
your access point shuts down, you must remove all power and reconnect only a single power source.