3com 980-000077/002 Manual De Usuario

example, if the central site unit is named “london”, then enter 

 

■

If the tables are working correctly and the ISDN lines are 
functioning properly, then the Enter Password screen on the 
central site unit will be displayed. Go to step 8, below.

2 If the Enter Password screen on the central site unit is not displayed 

within 30 seconds, Press [Ctrl]+[D] to return to the local unit 
management system screens. 

3 Press [Ctrl]+[V] to refresh the Remote Units screen.

4 If the central site unit name and IP address are not listed, make a 

manual call of 5 minutes duration. 

5 Enter 

 followed by the central site number.

6 While the call is up, press [Ctrl]+[V] at frequent intervals to refresh 

the Remote Units screen. When the central site unit name appears, 
cancel the manual call.

7 Enter 

 followed by the central site number. Follow step 1 in this 

section for testing the IP Autocall and ISDN Number tables.

If the central site unit name is not listed on the Remote Units screen 
after 5 minutes, carefully check the configuration of both the remote 
and central site units. Ensure that IP routing has been enabled on 
both units.

8 Enter 

 to close the remote management session or press 

[Ctrl]+[D] if that command cannot be used.

A unit at a remote site can be remotely configured as an IP router. 
The remote management and configuration capability allows the unit 
to be configured from the central site, without the need for a 
technician to travel to a remote site.

It is good practise to have ensured that the remote unit was restored 
to the factory default settings before being despatched to the 
remote site.

Get_con.bk : ROUT_IP.FRM  Page 9  Friday, October 3, 1997  1:49 PM