3com 980-000077/002 Manual De Usuario

C

HAPTER

 3: R

OUTING

 IP

It is important to enter static routes when configuring the unit to use 
unnumbered links because these routes will not be learned by the 
unit. Static routes must be entered at both ends of the link.

Set up the IP Routing table to associate an IP route with a unit name.

1 Enter 

 

 

 to display the Configured IP Routes screen.

2 Enter 

 to display the Add Routing Table Entry screen.

3 Type the IP address of the remote LAN in the Target field. 

4 Type a valid subnet mask for the remote network in the Subnet Mask 

field.

5 Type the name of the remote unit in the Router field. 

6 Press [Ctrl]+[E] to submit the new setting and then enter 

A manual call must be placed before the remote configuration of the 
remote unit can proceed.

1 Enter 

 

 

 to display the ISDN Numbers table.

2 Select the entry for the remote unit using the Arrow keys and enter 

3 Enter 

 to display the Remote Units screen. Refresh the screen by 

pressing [Ctrl]+[D] at regular intervals until an entry for 

NoName

 

appears.

4 Select the 

NoName

 

10.0.0.1

 entry using the Arrow keys and enter 

5 The Enter Password screen of the remote unit should be displayed 

within 30 seconds.

■

If the Enter Password screen is not displayed, check that the name 
and IP address for the remote unit have been entered correctly on 
the central site unit and that the ISDN line is connected and 
working normally at both ends of the link.

6 Enter 

 (in upper-case letters) when the Enter Password 

screen is displayed.

Get_con.bk : ROUT_IP.FRM  Page 12  Friday, October 3, 1997  1:49 PM