Cisco Systems 78-13983-04 Manual De Usuario
4-23
Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide
78-13983-04
Chapter 4
Configuring with the Command-Line Interface
Monitoring and Managing the MWR 1900
Step 6
Enter the following commands to specify the public and private SNMP community names:
Router(config)# snmp-server community public RO
Router(config)# snmp-server community private RW
Step 7
Enter the following command to enable the sending of SNMP traps:
Router(config)# snmp-server enable traps
Step 8
Enter the following command to specify the loopback interface from which SNMP traps should
originate:
originate:
Router(config)# snmp-server trap-source loopback number
Where number is the number of the loopback interface you configured for the O&M in
Step 9
At the configuration prompt, press Ctrl-Z to exit configuration mode.
Step 10
Write the new configuration to nonvolatile memory as follows:
Router# copy running-config startup-config
Show Commands for Monitoring the MWR 1900
To monitor and maintain the MWR 1900 router (including the multilink, VWIC, and FE interfaces) and
to view information about the PPP mux and header compression configuration, use the following
commands:
to view information about the PPP mux and header compression configuration, use the following
commands:
Command
Purpose
show ip rtp header-compression
Displays RTP header compression statistics.
show interface fastethernet slot/port
Displays the status of the FE interface.
show ppp multilink
Displays MLP and multilink bundle information.
show ppp multilink interface number
Displays multilink information for the specified
interface.
interface.
show ppp mux interface interface
Displays statistics for PPP frames that have passed
through a given multilink interface.
through a given multilink interface.
show controllers fastethernet slot/port
Displays information about initialization block,
transmit ring, receive ring and errors for the Fast
Ethernet controller chip.
transmit ring, receive ring and errors for the Fast
Ethernet controller chip.
show controllers t1
Displays information about the cable length, framing,
firmware, and errors associated with the T1. With the
MWR 1900, this command also displays the status of
the relays on the VWIC.
firmware, and errors associated with the T1. With the
MWR 1900, this command also displays the status of
the relays on the VWIC.
show redundancy
Displays current redundant setting and recent
changes in state.
changes in state.
show standby
Displays HSRP configuration information.
clear counters fastethernet slot/port
Clears interface counters.
clear ppp mux interface
Clears the PPP mux counters on the specified
interface.
interface.
clear ip rtp header-compression
Clears RTP header compression structures and
statistics.
statistics.