Cisco Systems 78-13983-04 Manual De Usuario
5-9
Cisco MWR 1900 Mobile Wireless Edge Router Software Configuration Guide
78-13983-04
Chapter 5
Command Reference
ppp mux delay
ppp mux delay
To set the maximum time the processor can wait before sending a superframe, use the ppp mux delay
command in interface configuration mode. To set the maximum delay to the default, use the no form of
this command.
command in interface configuration mode. To set the maximum delay to the default, use the no form of
this command.
ppp mux delay integer
no ppp mux delay
Syntax Description
Defaults
The default maximum delay is 0, which indicates that a superframe will be sent when the transmit queue
is full.
is full.
Command Modes
Interface configuration
Command History
Usage Guidelines
To use this command, you must first enable PPP multiplexing/demultiplexing.
Examples
The following example sets the maximum delay to 5 microseconds.
ppp mux delay 5
Related Commands
integer
The maximum number of microseconds that the processor can wait before
sending out a PPP superframe. Possible values are 0 through 4000000
microseconds.
sending out a PPP superframe. Possible values are 0 through 4000000
microseconds.
Release
Modification
12.2(8)MC2
This command was introduced.
Command
Description
ppp mux
Enables PPP multiplexing/demultiplexing
ppp mux frame
Sets the maximum length of the PPP superframe.
ppp mux pid
Sets the default PPP protocol ID.
ppp mux subframe count
Sets the maximum number of subframes in a superframe.
ppp mux subframe length
Sets the maximum length of the PPP subframe.
show ppp mux
Displays PPP mux counters for the specified multilink interface.