Siemens 2614 Manual De Usuario

If Internet services are provided through an xDSL or cable modem, use unshielded or shielded twisted-
pair Ethernet cable with RJ-45 plugs to connect the broadband modem directly to the WAN port on the 
SpeedStream 2614. Use either straight-through or crossover cable depending on the port type provided 
by the modem (see Appendix B, “Cables”). For ISDN or PSTN service, attach the access device to the 
RS232 serial port on the SpeedStream 2614

4. Connect a printer. By connecting a printer to the SpeedStream 2614, all computers connected to your 

LAN can access print services. Connect a standard parallel printer cable to the printer port on the 
SpeedStream 2614 and configure printer services as instructed in Chapter 5, “Configuring Printer 
Services.”

5. Connect the power adapter and power up the router, modem and network computers. Plug the 

power adapter into the power socket on the SpeedStream 2614, and plug the other end into a power 
outlet. Check the Power indicator on the front panel to be sure it is on. If the Power indicator does not 
light up, refer to Appendix A, “Troubleshooting.” 

6. Verify the port status. Confirm that all connections are successful by checking the power and port 

status indicators as shown in the following table.

Power

n/a

Green

On 

SpeedStream 2614 is receiving power.

WAN

n/a

Green

On 

The WAN port has established a valid network connection.

Flashing 

The WAN port is transmitting or receiving traffic.

LAN

- Link/Act

1-4

Green

On 

The indicated LAN port has established a valid network 
connection.

Flashing

The indicated LAN port is transmitting or receiving traffic.

- 10/100

1-4

Amber

On

The indicated LAN port is operating at 100 Mbps.

Flashing

The indicated LAN port is operating at 10 Mbps.