Lantronix 1-T2 Manual De Usuario

Using the MSS

Incoming Connections

If heavy input or output loads are expected on the LTA port, you can set 
alternate type ahead to reduce ßow control on the ports.

Reducing Flow Control

To connect to the MSS serial port from a VMS host, use the command below 
and include the appropriate LAT application port number:

Connecting to the MSS

The MSS can be used with applications on Unix, Windows, Windows NT, 
OS/2, LAT, and Macintosh hosts, and any other hosts that have a TCP/IP or 
SPX socket interface. 

When a host application makes a socket connection to the MSS, it uses the 
socket as a data pipe to send and receive data. The host application performs 
general read/write tasks, and works with the MSS as if it were a directly-
attached serial device.

There are some important points to remember when making a socket 
connection.

¥

Port access must be set to either Dynamic or Remote to allow network 

connection requests. Local access does not allow a port to receive 
connection requests from the network. To change the portÕs access 
type, use the Change Access command followed by either Dynamic or 
Remote

. 

¥

The port must be idle. Use the Show Ports command to verify that the 

port is not in use. To ensure that the port will be idle, Telnet to the 
remote console port rather than attaching a terminal to the serial port.

¥

Only one serial port connection is allowed at a time.

¥

Timing and serial signals are not preserved.

$ SET TERM/PERM/ALTYPEAHD LTA

nnnn

$ SET HOST/DTE lta

nnnn