Linksys WAP54A Manual De Usuario

Wireless Access Point

Instant Wireless

TM

Series

Chapter 3: Getting to Know the

Wireless Access Point

The Access Point’s ports, where a network cable is connected, are located on
the Access Point’s rear panel, as shown in Figure 3-1.

This  LAN (Local Area Network) port connects to
Ethernet network devices, such as a hub, switch, or
router.

The Power port is where you will connect the  power
adapter.

Reset (Button)

Briefly pressing the Reset Button, for approximately ten
seconds, will refresh the Access Point’s connections,
potentially clearing any jammed links. 

4

The Access Point’s LEDs, where information about the unit’s current status is
displayed, are located on the Access Point’s front panel, as shown in Figure 3-
2.

Green. The Power LED lights up when the Access Point is
powered on.

Green. If the LED is flickering, the Access Point is actively
sending or receiving data to or from one of the devices on the
network.

Green. The LINK LED serves two purposes. If the LED is
continuously lit up, the Access Point is successfully connect-
ed to a device through the LAN port. If the LED is flicker-
ing, it is an indication of any network activity.

Important: Resetting the Access Point will erase all of your settings
(WEP Encryption, Wireless and LAN settings, etc.) and replace
them with the factory defaults. Do not reset the Access Point if you
want to retain these settings.

5