Toshiba S2T Manual De Usuario

 

 

 

                                           

 Programmable Controllers 

Rev 051115 

Ethernet Setup for the S2T 

 
Ethernet communications with the S2T CPU is done through the GEN651A Ethernet module.  
Prior to using this module, it must be configured using the EtherSetup_E setup software.  The 
EtherSetup_E software is used to configure the network parameters (IP Address, Subnet 
Mask, and Multicast Addresses) in the GEN651A Ethernet module.  When all the following 
setup steps described below are completed, Ethernet connection to the S2T through the 
GEN651A Ethernet module will be possible.   There are two methods of connection: 

● T-PDS (Toshiba Program Development Software).  ● UDP/IP Socket Interface.  

 

This module must be setup 1

st

 before either of the connections methods are possible. 

1, Install the EtherSetup_E software on an MS Windows computer.  See the installation 
instructions in the User’s Guide for the Ethernet Module Parameter Setting Tool, 

6F8C1103.

 

 
2

, 

 Set the network parameters in the GEN651A module. 

 

2.1  Set the DIP switches on the front of the EN6651A to enable setting the network 
parameters from the EtherSet_E.   Set DIP Switches 7 & 8 to ON (Note: 7 & 8 are the top 
two switches). 
 
2.2  Mount the EN651A on the S2T rack, then turn on power. 
 
2.3  Connect PC and EN6651A with the V-Tool cable (standard RS232C cross cable). 
 
2.4  Run the EtherSet_E software on the PC. 
 
2.5  Click the Read button on the EtherSetup_E screen. The current settings are read from 
the GEN651A and are displayed on the screen. 
 
 

On reading a module for the 
1

st

 time, settings will appear as 

shown to the left.