Nortel Networks AN/DC Manual De Usuario
Installing and Operating AN/DC and ANH-8/DC Systems
2-14
312410-A Rev 00
Figure 2-9.
ANH-8/DC Front-Panel MDI-X/MDI Switch
Connecting the ANH-8/DC to Other Repeaters/Hubs
You can use Port 1 in MDI configuration to connect to a 10Base-T MDI-X port on
another router/hub/bridge device using UTP straight-through RJ-45 patch cables
(instead of a special crossover cable). You can interconnect (daisychain) as many
as four 8-Port ANH-8/DC or other hub systems.
another router/hub/bridge device using UTP straight-through RJ-45 patch cables
(instead of a special crossover cable). You can interconnect (daisychain) as many
as four 8-Port ANH-8/DC or other hub systems.
To determine whether you need to use a crossover cable or straight-through cable
to interconnect hub units, consider the following:
to interconnect hub units, consider the following:
•
If the Ethernet UTP ports on both hubs are in MDI mode, use a crossover
cable.
cable.
•
If the UTP ports on both hubs are in MDI-X mode, use a crossover cable.
•
If the UTP port on one hub is in MDI mode, and the UTP port on the other
hub is in MDI-X mode, use a straight-through cable.
hub is in MDI-X mode, use a straight-through cable.
MDI-X/MDI
Reset
Power
Fault
Console
Boot Run DCM AUI Part
DCD1 DCD2 <LAN> Col
AUI
Partition
Link
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
MDI-X/MDI
MDI-X
AN0056A