Cisco Systems 3515 MCU24 Manual De Usuario
C H A P T E R
2-1
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU Release 5.6
OL-17012-01
2
Setting Up Your Cisco Unified
Videoconferencing 3515 MCU
Videoconferencing 3515 MCU
•
•
•
•
•
•
•
•
Physical Description
Each Cisco Unified Videoconferencing 3515 MCU unit internally contains two cards:
•
Signaling and audio card (MCU—the upper card)
•
Video processing card (EMP—the lower card)
The two cards work together to perform audio and videoconferencing, but each card requires a unique
IP address. The cards communicate with each other using IP as the backbone.
IP address. The cards communicate with each other using IP as the backbone.
Note
For correct operation, the EMP card must register with the MCU.
This section provides a physical description of the Cisco Unified Videoconferencing 3515 MCU12 and
Cisco Unified Videoconferencing 3515 MCU24 units.
Cisco Unified Videoconferencing 3515 MCU24 units.
The Cisco Unified Videoconferencing 3515 MCU unit has a 10/100BaseT Ethernet port on the front
panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial-port
that you can use with a hyperterminal program to configure and monitor the module.
panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial-port
that you can use with a hyperterminal program to configure and monitor the module.
shows the front panel of the Cisco Unified Videoconferencing 3515 MCU unit.
describes the components of the front panel.