ZyXEL Communications n/a Manual De Usuario

 Chapter 21 WAN Commands

DSL & IAD CLI Reference Guide

The following example:

• Sets the active node profile to node 1 (the ISP node profile).

• Sets the profile name to "ISP1".

• Sets the multicast mode to IGMP version 2.

• Sets the NAT mode to SUA only.

• Sets the PPP authentication method to CHAP.

• Sets the PPP username to "User1".

• Sets the PPP password to "Pass1".

• Sets the PPP idle timeout to 240 seconds.

• Sets the remote gateway IP address to 192.168.1.254, with a subnet mask of 

255.255.255.0.

• Activates IP routing.

• Sets the service name to "ISPservice".

• Sets the VPI to 30 and the VCI to 33.

• Sets the WAN IP address to be dynamic.

• Saves the settings.

• Sets the active node profile to node 2 again.

wan node routeip <on|off>

Activates or deactivates IP routing on the 
previously-specified WAN node profile.

wan node save

Saves configured information about the WAN node 
you previously specified with the wan node index 
<node#>

 command to the permanent memory.

Note: Changes to the configuration in the 

working buffer are not saved or 
used until you enter this command.

wan node scr <scr>

Sets the Sustainable Cell Rate (SCR) of the 
previously-specified WAN node profile.

wan node service <name>

Sets the PPPoE service name of the previously-
specified WAN node profile.

wan node vci <vci>

Sets the VCI (Virtual Channel Identifier) of the 
previously-specified WAN node profile.

wan node vpi <vpi>

Sets the VPI (Virtual Path Identifier) of the 
previously-specified WAN node profile.

wan node wanip <<static> 

<ip>>|<dynamic>

Sets the WAN IP address of the previously-specified 
WAN node profile.

Table 66   wan node Commands (continued)