Barco 26-0405000-00 Manual De Usuario
18
PresentationPRO-II • User’s Guide
2. Hardware Orientation
Front Panel Sections
~
The
Bottom knob is used to adjust the adjacent parameter, as labeled
on the Touch Screen.
pçìêÅÉ=pÉäÉÅíáçå=_ìë
The figure below illustrates the
Source Selection Bus.
Figure 2-4. Source Selection Bus
Each button represents an input that you can assign to a PIP or a key.
•
Buttons
1 through 8 correspond to the eight analog inputs on the rear panel.
•
The
SDI button corresponds to the SD-SDI input (SDI Model) or the SD-SDI / HD-
SDI input (HD Model) on the rear panel.
Press a button on the
Source Selection Bus to assign the source to the blinking PIP or
Key effect in the
Layer Functions Section.
•
A source button that is blinking indicates that the source is “pending.” It has been
assigned as the next PIP or Key source, and can be taken to Program with the
next transition.
assigned as the next PIP or Key source, and can be taken to Program with the
next transition.
•
When a source button is lit solid, the source is on Program. It cannot be modified
until its associated PIP or Key button is pressed and blinking.
until its associated PIP or Key button is pressed and blinking.
•
One solid source (Program) and one blinking source (pending) can appear on the
Source Selection Bus simultaneously.
Source Selection Bus simultaneously.
In Chapter 5, refer to the “
all source setup procedures.
Important
There is no
Enter button. If you adjust a value with the
knobs, that function or value is immediately active.
6
7
8
SDI
1
2
3
4
5
Source Selection