Microboards Technology II Manual De Usuario

    

                                                                        Orbit II Disc-to-Disc Copier Reference Manual – Revision I

 

 

24 

 
 
Verify the distribution disc was copied properly: 
 

•  Take the distribution disc copy from the Accept Basket and place it in the Input Hopper.  

 

•  Press the     No     key at the              

                      and     or    

        

 

      

prompts. 

 
•  Press the     Yes     key at the  

 

 

 

       prompt. 

 
•  When the    

 

 

 

 prompt appears, press   Yes    to accept the “10s” 

digit setting of  “0”.     The underline cursor will move to the “1s” digit.  Press the    No   key once 
to set the “1s” digit to “1”.  Press   Yes    to accept the “1s” digit setting of  “1”. 

 

•  When the CD Reader tray opens, place the Orbit II distribution disc in the CD Reader tray and 

press   Yes   . 

 
•  Orbit II will compare the master distribution disc to the copy, and place the copy in the Accept 

Basket if it passes the content verification test. 

 
You can use this same test sequence to troubleshoot problems with your Orbit II System prior to calling for 
technical assistance.  If you are trying to isolate media quality problems, substitute reference media for 
discs that have a high reject rate.  If you suspect problems with a particular master, substitute a reference 
master.  (You can use your distribution disc as a reference master.)  If the term “reference media” or 
“reference master” is new to you, refer to Sections 3 & 4 of this manual. 
 
When your Orbit II System passes the disc handling, writer, and reader tests it is ready for use.  Proceed to 
Section 6 Basic Orbit II Operation. 
 
If your Orbit II System does not pass the disc handling, writer, or reader test contact your Microboards 
Technology Technical Support for assistance.