Bacharach 24-7224 Manual De Usuario

Bacharach, Inc. 

 

Standard Length ......................................................... 11.5 in (295 mm)

 

Optional Lengths ............................................................. 7 in (180 mm)

 

 

19.5 in (500 mm)

 

 

39 in (1000 mm)

 

Inlet Sample Dew Point.......................................... 149 °F (65 °C) max.

 

Outlet Sample Dew Point .................18 °F (10 °C) min. below ambient

 

Cooling Power ................................................................................. 10 W

 

Environment Temperature .............................32 to 104 °F (0 to 40 °C)

 

Weight ................................................................................8.5 oz (240 g)

 

Sample Flow Rate ..........................................................1.5 LPM @ STP

 

Length of Hose ...................................................................... 6.6 ft (2 m)

 

Reservoir Storage ........................................................................... 50 ml

 

Environment Temperature .............................32 to 104 °F (0 to 40 °C)

 

Weight ..............................................................................12.7 oz (360 g)

 

Input ..............................................................100 to 240 VAC, 50/60 Hz

 

Output ............................................................ 9 VDC, max. @ 4 A, max.

Refer to Figure 2. If not already done, attach the Peltier cooler to the 

probe assembly by first removing the plastic end cap from the rear of 

the probe, and then inserting the cooler’s inlet connector, ensuring first 

that a filter is present between the cooler and probe.
Attach the pump’s inlet hose to the bottom of the Peltier cooler. Water 

that is condensed from the flue-gas sample will be pumped into the con-

densate pump’s reservoir through this hose. Note that the condensate 

pump can be placed in an upright, horizontal, or hanging position. A 

magnet mounted in the base of the pump allows the pump to be at-

tached to overhead ductwork.
Connect the power supply’s DC output connector to the condensate 

pump; then connect the condensate pump’s DC output power connector 

to the Peltier cooler. The Peltier cooler and its associated condensate 

pump are started by plugging the power supply into a source of AC 

power that is between 100 and 240 VAC, 50/60 Hz. 
Connect the probe assembly’s stack-temperature thermocouple con-

nector, pressure fitting, and flue-gas fitting to the combustion analyzer 

per the analyzer’s instruction manual.