Genie 3064H Manual De Usuario

Puts an invisible beam across the door opening.  The door stops and reverses to the full open position if anything 
passes through the beam.  LED indicator lights on the powerhead and on the STBs provide a self diagnostic code 
if an operational problem exists.

Automatically stops and reverses a closing door within two seconds of contact with an object.

Automatically sets the force required to fully open and close the door for maximum safety.

Monitors the Safe-T-Beam® system to ensure proper functionality and will automatically stop and reverse a 
closing door if a problem is detected.

Manually releases door from door opener.  Used during a power failure or other emergency to allow manual 
opening and closing of door.

Easily adjust the programming to reduce opening speed to a desired rate, vary limits and force, and program new 
remotes.

Two bulb lighting system supplies up to 200 Watts of light for safer evening exits and entries.  Turns ON when 
door is activated and automatically turns OFF 4 minutes later.

(Not available on all models)

Select units have motion detection built into the powerhead.  Lights automatically turn ON when motion is 
detected for much safer movement through the garage.  Lights will turn OFF after 4 minutes of no motion.

©2010     The Genie Company 

12/2010

3

A new generation superior encryption system  that enhances the security of the door opener by continuously 
changing the access code each time the remote is used.  The door opener responds to each new code only once.  
An access code copied from a working system and tried again will not control the door opener.

Operates door opener from inside garage.  The Wall Console has an Indicator Light with: Open/Close, Sure-Lock™, 
and Independent Light Control buttons.

 and Car2U® compatible.  Refer to the programming instructions on page 10 and then 

follow the HomeLink® or Car2U® instructions in your car owner’s manual.