Goodman Mfg GAS-FIRED WARM AIR FURNACE Manual De Usuario

22

Upright installations using the alternate vent/flue outlet will require
“right-side only” drain hoses to be connected as follows.  Refer to
Vent/Flue Pipe and Combustion Air Pipe for details on alternate
vent/flue pipe connection.

1. Remove the rubber plug from the right-side drain port on

the front cover . Save for use in step 3.

2. Secure Hose A to front cover drain port with a red hose

clamp. Route hose to rear right side panel grommet hole.

3. Remove grommet from front right-side panel drain hole.

Seal hole in grommet with large end of plug.  Reinstall
grommet and plug into side panel drain hole.

4. Cut 1/4 inch from the end of the drain port on the externally

mounted rubber elbow.  Discard cut portion.

5.

Insert Tube 1 into rubber elbow drain port and secure with a
silver hose clamp.  Angle tube toward trap.

6.

Cut 17 3/4 inches from the long end of Hose B and discard.

7.

Secure straight end of Hose B to exposed end of Tube 1
with a green hose clamp.  Route hose toward right side
panel grommet holes.

8.

Insert short end of one Tube 2 through rear right side panel
grommet drain hole.  Secure tube to Hose A with a green
hose clamp.

9.

Insert short end of remaining Tube 2 into Hose B from
rubber elbow and secure with green hose clamp.  Ensure
hoses and tubes maintain a downward slope for proper
drainage and are not kinked or binding.

Upright “Alternate: Connections - Right Side Only