CFM UVHK29MN Manual De Usuario

15

The logs must be positioned ONLY as illustrated in Figures 12, 
13 and 14

• 

Position the front log so that the large notch in the underside 
of the right end of the log fits securely and rests on the sheet 
metal control cover as shown in Figure 15.  The front right 
end of the log has a ‘V’ shaped notch to touch the back of the 
right-hand grate bar as shown in Figure 16.  The left under-
side of the front log has a tab that will fit into mating slot in the 
ember base.  When the log is properly placed, there should 
be no gap between the right underside of the front log and 
the top edge of the ember base.

 

• 

Position the rear log so that the notches in the back of the 
log go around and up against the vertical bars of the grate 
assembly.  Install the rear log behind the log spacer brackets.  
The bracket in the center of the burner assembly must fit into 
the hole in the center underside of the back log. (Refer to 
Figure 17 for proper placement of the rear log.)

• 

Position the top log so that its tongue fits securely into the slot 
on the top of the rear log and the peg fits into the hole in the 
top of the front log.  The top log, when properly positioned, 
establishes the correct spacing between the front and rear 
logs.

• 

The left and right twigs are to be placed into the appropriate 
notches provided in the front and rear logs as shown.  (Figs. 
12, 13 and 14)

• 

When using the Charred Oak log set  the rear standoff must 
be cut to allow the rear log to be positioned properly.  (Fig. 
17)

ENSURE THAT THE LOGS ARE CENTRAL AND VERTICAL 
AS SEEN FROM THE SIDE.  TO PREVENT UNWANTED 
SOOTING, THE FLAME FROM THE BACK BURNER SHOULD 
NOT TOUCH ANY LOG.
CAUTION:  Proper location is critical.  When positioning the log 
set, make sure that the logs do not interfere with the sides of 
the fireplace before securing the chassis.

The fireplace screen must be in place when the appliance is 
operating and unless other provisions for combustion air are 
made, the screen must have openings for the introduction of 
combustion air.

The volcanic ash from the bag provided should be sprinkled 
over the baseplate in front of and below the main burner.  Do 
not sprinkle this material on the fiber base, around the pilot or 
on the main burner.

Fig. 12  Split Bark logset position.