Heath Zenith PF-4170-PB Manual De Usuario

2

Estimated Installation Time: 30 minutes
Items needed for installation (not included):
•  Phillips and flathead screwdrivers
•  Pliers 

•  Wire strippers/cutters

•  Safety glasses  •  Light bulb
•  Silicone caulk
For best performance, mount the fixture about 
6 feet (1.8 m) above the ground.

1. Remove two nuts.

3. Tighten screws 

finger tight.

2. Remove 

Mounting Plate.

*  If you get confused while switching modes, 

turn the power off for one minute, then back 
on. After the calibration time the control will 
be in the AUTO mode.

MANUAL MODE

AUTO

TEST

This fixture comes with a universal mounting 
bracket. It is pre-assembled on the fixture to 
fit the majority of junction box applications.
However, if the slots on the mounting plate 
do  not  line  up  with  the  junction  box  screw 
holes:
1.  Remove the fixture mounting screws from 

the mounting plate. Note: Do not remove 
the ground screw.

2.  Attach  ground  wire  “pigtail”  to  ground 

screw  on  mounting  plate  (See 
Recommended  Grounding  Method  for 
additional information).

3.  Flip the mounting plate over.
4.  Rotate the mounting plate so the wire path 

is on the upper right. Note: The wire path 
on the mounting plate must be located 
as shown below to allow the wires on the 
back of the fixture to pass through.

5.  Reinstall the fixture mounting screws and 

attach the mounting plate to the junction 
box as shown.

Wire Path

4. Attach mounting plate to junction box.

Wire Path

Ground Screw

Wire Path

Fixture Screws

Ground Screw