DMP Electronics LT-0229 (5 97) Manual De Usuario

Page 10

2841 E. Industrial Drive  Springfield, MO  65802-6310  800-641-4282

To configure the XR10/XR20 for ground start operation, you must install the appropriate ground start module and
program one of the panel's available annunciator outputs for Ground Start operation. Refer to the XR10/XR20
Programming Guide for complete programming information.

There are two reset jumpers located at the top right of the panel's circuit board labeled RESET. Momentarily
shorting these jumpers allows you to reset the microprocessor of the XR10/XR20. Resetting the panel allows
you to enter the panel's internal Programmer.

To reset the panel when first installing the system, place the blade of a slotted screwdriver across the two reset
jumpers after applying power to the panel.

To reset the panel while the system is operational (for example, prior to reprogramming), you can short the
jumpers without powering down the system.

After resetting the panel for programming, you must begin within 30 minutes. If you wait longer than 30 minutes,
you'll have to reset the panel again.