Cisco Systems PA-MC-8TE1 Manual De Usuario
l3vpn encapsulation ip
To configure an L3VPN encapsulation profile, use the l3vpnencapsulationip command in global configuration
mode. To remove the encapsulation profile, use the no form of this command.
mode. To remove the encapsulation profile, use the no form of this command.
l3vpn encapsulation ip profile name
no l3vpn encapsulation ip profile name
Syntax Description
Name of the Layer 3 encapsulation profile.
profile name
Command Default
The L3VPN encapsulation profile is not configured.
Command Modes
Global configuration (config)
Command History
Modification
Release
This command was introduced.
12.2(33)SRE
Usage Guidelines
When you use the l3vpnencapsulationip command you enter into L3VPN encapsulation configuration mode.
You can then specify the transport source mode and interface using thetransportipv4 command, set the GRE
key using the protocolgre command, and configure the L3VPN encapsulation profile.
You can then specify the transport source mode and interface using thetransportipv4 command, set the GRE
key using the protocolgre command, and configure the L3VPN encapsulation profile.
Examples
The following example shows how to configure an L3VPN encapsulation profile:
Router(config)# l3vpn encapsulation ip tunnelencap
Related Commands
Description
Command
Displays the profile health and the underlying tunnel
interface.
interface.
show l3vpn encapsulation ip
Specifies IPv4 transport source mode and the transport
source interface.
source interface.
transport ipv4
Specifies GRE as the tunnel mode and sets the GRE
key.
key.
protocol gre
Cisco IOS Interface and Hardware Component Command Reference
17
l2 vfi manual through loopback PA-MC-8TE1 + port adapter
l3vpn encapsulation ip