Sunwave Tech. SRC-3810 Manual De Usuario
SRC-38 SERIES User’s Manual
24
Debugging Device Codes
Use this procedure if the SRC-3810/3815 is unable to
recognize the infrared signals from another remote
control.
Once you have collected unrecognizable codes, you
recognize the infrared signals from another remote
control.
Once you have collected unrecognizable codes, you
can use the optional SLC–2080 link cable (see
Appendix B - Accessories on page 47 for more info) to
upload the unrecognized codes to your personal
computer and then email them to SUNWAVE for
analysis. SUNWAVE can then update the system
Appendix B - Accessories on page 47 for more info) to
upload the unrecognized codes to your personal
computer and then email them to SUNWAVE for
analysis. SUNWAVE can then update the system
firmware and send you an updated version that will
recognize the codes.
SUNWAVE service email address is:
recognize the codes.
SUNWAVE service email address is:
support@sun-wave.com
All unrecognized codes should be sent to this address.
Every time you enter DEBUG mode, the SRC-
3810/3815 replaces previously stored unrecognized
codes with new ones. If you have more than one
remote that is not programmable, upload the first
remote’s unrecognized codes and then gather the
second remote's unrecognized codes.
3810/3815 replaces previously stored unrecognized
codes with new ones. If you have more than one
remote that is not programmable, upload the first
remote’s unrecognized codes and then gather the
second remote's unrecognized codes.
Set up the LCD display before using this function. See
LCD Layout on page 26.
LCD Layout on page 26.