Life Fitness Hammer Strength Linear Leg Press Manual De Usuario

 

 

 
1. Frame Construction 
•  Frame is constructed of mechanical quality steel purchased in mill run quantities 

•  Frame is primarily 2” x 4”  and 2” x 3” rectangular tubing with 11 gauge wall 

thickness. Frames are fully welded and bolt together for maximum structural integrity 
and minimum maintenance when possible. However, larger machines have bolt-
together configuration to facilitate movement through smaller doorways and difficult 
installations 
 

2. Frame Finish 
•  Prior to applying finish, each part is chemically washed to prepare surface for 

maximum adhesion 

•  The frames are coated with an electrostatic epoxy powder coat finish applied in a 

powder form and then baked at 400

° F (204° C.)  

•  To prevent frame and surface corrosion, wax equipment annually and keep away 

from salt, chlorine and all other harmful chemicals 
 

3.  Linear Guidance System 
•  Two 1-1/4” precision case hardened linear shafts 

•  Four individual self aligning 1-1/4” linear bearings held in place with snap rings for 

easy maintenence 

•  Custom designed heavy duty 2-1/2” bearing housing 
 
4. Racking System 
•  Dual independent carriage catch and release handles simple intuitive operation 

•  Four position adjustable stop to accommodate a wide range of users 

 

5. Weight Plate Holders 
•  Durable chrome-nickel plating on all weight plate holders 

•  Four built in holders accommodate Olympic plates 
 
6. Bolts 
•  All hardware is stainless steel, zinc plated or nickel plated 

 

7. Upholstery 
•  Contoured pads on selective units 

•  All edges are stitched to eliminate any folds in the material that would limit durability. 

 

8. Foam 
•  Three and Four pound EVA foam (deformation resistant) or equivalent is used on all 

machines. The foam is injection molded directly to the multi-ply wood support board 
with integral 10mm T-nuts.