Fujitsu V3.1 Manual De Usuario
You configure the network parameters of an I/O connection blade as follows:
l
Activate the Enable DHCP option under Management Port Settings if
the connection blade is to receive its IP address from a DHCP server. If
this option is not activated, you must specify the IP address, subnet
mask, and the gateway address.
the connection blade is to receive its IP address from a DHCP server. If
this option is not activated, you must specify the IP address, subnet
mask, and the gateway address.
l
Click Apply to activate the settings.
4.2.4
Connecting IBP modules
The PY CB Eth Switch/IBP 1Gb 36/8+2, PY CB Eth Switch/IBP 1Gb 36/12
LAN, PY CB Eth Switch/IBP 1Gb 18/6, and PY CB Eth Switch/IBP 10 Gb
18/8 connection blades support two modes:
LAN, PY CB Eth Switch/IBP 1Gb 18/6, and PY CB Eth Switch/IBP 10 Gb
18/8 connection blades support two modes:
l
"Normal" Layer 2 switch mode
l
IBP mode
For information on how to perform the switch, refer to the Switch Blade user
manual.
manual.
ServerView Virtual-IO Manager
115
4.2 Configurations on the managed BX400 Blade Server