Fujitsu V3.1 Manual De Usuario
4 Configuration
monitoring, spanning tree protocol, VLAN, etc. The entire stack will appear
as a single IBP.
as a single IBP.
You find a detailed description about Switch Stacking in the manual "PRIM-
ERGY BX900 Blade Server Systems- Ethernet Connection Blade Module-
IBP version (User`s Guide)", chapter 6.
ERGY BX900 Blade Server Systems- Ethernet Connection Blade Module-
IBP version (User`s Guide)", chapter 6.
VIOM supports uplink sets and networks on switch stacks. An uplink set can
contain uplink ports from different IBPs in a stack. You can see stacks in the
VIOM GUI on the Setup tab if you click on a stack member. Then all
members of this stack are highlighted: the stack master is yellow shaded; all
other members are green shaded. Beside this, Stack Master or Stack
Member is shown in the details area.
contain uplink ports from different IBPs in a stack. You can see stacks in the
VIOM GUI on the Setup tab if you click on a stack member. Then all
members of this stack are highlighted: the stack master is yellow shaded; all
other members are green shaded. Beside this, Stack Master or Stack
Member is shown in the details area.
To define, modify, or delete uplink sets and networks in a stack, select one
stack member and start the desired operation. Details can be found in
stack member and start the desired operation. Details can be found in
.
4.3
Configurations on the managed BX900 Blade
Server
Server
In section
, you can find out what combinations of I/O connection blades are
supported by VIOM.
To manage a blade server with VIOM, you must carry out the following pre-
paratory steps:
paratory steps:
l
Configure the management blade or management blades, see section
l
Configure the I/O connection blades, see section
l
Define the connection of the IBP modules with the network, see section
l
Add the blade server to the server list of the ServerView Operations Man-
ager, see section
ager, see section
118
ServerView Virtual-IO Manager