Samsung HT-TX22 Manual De Usuario
ENG
25
24
OPERA
TION
Before Using Your Home Theater
To Operate your Samsung TV and the Home Theater with the HT-X20/HT-TX22/HT-TX25's Remote Control
1
Plug the main unit's power cord into the AC power supply.
■
Before plugging your system into a main socket, you must check the voltage setting.
If the voltage of the socket does not correspond to the setting on the rear of the unit, you
may seriously damage your system.
If the voltage of the socket does not correspond to the setting on the rear of the unit, you
may seriously damage your system.
2
Press the
TV
button to set the remote to TV mode.
3
Press the
POWER
button to turn on your Samsung TV
with this remote.
4
Press the
TV/VIDEO
button to select VIDEO mode on your TV.
5
Press the
DVD RECEIVER
button to switch to DVD RECEIVER mode to
operate the DVD Home Theater
6
Press the
FUNCTION
button on the main unit or
DVD
button
on the remote to enable DVD/CD playback.
VIDEO
The DVD Home Theater's remote can be used to control Samsung TVs.
Press and hold the
NT/PAL
button on the remote controller for over 5 seconds
while the power is turned off.
By default, the video format is set to <PAL>.
<NTSC> or <PAL> will appear in the display. At this time, press the
NT/PAL
button shortly to
select between <NTSC> and <PAL>.
Each country has a different video format standard.
For normal playback, the video format of the disc must be the same as the video format of your TV.
Selecting the Video Format
Disc Playback
1
Press the
OPEN/CLOSE
button to open the disc tray.
2
Load a disc.
■
Place a disc gently into the tray with the disc’s label facing up.
3
Close the compartment by pressing the
OPEN/CLOSE
button again.
■
Playback starts automatically.
• Depending on the content of the disc, the initial screen may appear different.
• Pirated discs will not run in this player because it violates the CSS (Content Scrambling System : a copy protection system) rec-
• Pirated discs will not run in this player because it violates the CSS (Content Scrambling System : a copy protection system) rec-
ommendations.
To stop playback, press the
STOP ( )
button during playback.
■
If pressed once, <PRESS PLAY> is displayed and the stop position will be stored in memory.
If the
PLAY/PAUSE (
)
button or
ENTER
button is pressed, playback resumes from the stop position.
(This function works only with DVDs.)
■
If pressed twice, <
STOP
> is displayed, and if the
PLAY/PAUSE (
)
button is pressed, playback starts from the
beginning.
To temporarily pause playback, press the
PLAY/PAUSE
(
)
button during playback.
■
To resume playback, press the
PLAY/PAUSE (
)
button again.
DVD
VCD
CD
X20(1~39P) NOGB 2007.4.12 12:52 PM Page 24