Toshiba 19SL400U Manual De Usuario

39)  For added protection of your TV from lightning 

and power surges, always unplug the power 

cord and disconnect the antenna from the TV if 

you leave the TV unattended or unused for long 

periods of time.

40)  ALWAYS unplug the TV to completely disconnect 

from mains power. When the TV is turned off using 

the on/off switch, it is not completely disconnected 

from power and a minute amount of current is still 

consumed.

41)  During normal use, the TV may make occasional 

snapping or popping sounds. This is normal, 

especially when the unit is being turned on or off. If 

these sounds become frequent or continuous, unplug 

the power cord and contact a Toshiba Authorized 

Service Center.

42) 

Never strike the screen 

with a sharp or heavy 

object.

43)   • The LCD screen of this product can be damaged

by ultraviolet radiation from the sun. When 

selecting a location for the television, avoid 

locations where the screen may be exposed to 

direct sunlight, such as in front of a window.

•  Never touch, press, or place anything on the LCD 

screen. These actions will damage the LCD screen. 

If you need to clean the LCD screen, follow the 

instructions in item 35 on page 4.

Service

44) 

Never attempt to service the TV yourself. Opening 

and removing the covers may expose you to 

dangerous voltage or other hazards. Failure to follow 

this WARNING may result in death or serious injury. 

Refer all servicing not specified in this manual to a 

Toshiba Authorized Service Center.

45)  If you have the TV serviced:

•  Ask the service technician to use only replacement 

parts specified by the manufacturer.

•  Upon completion of service, ask the service technician 

to perform routine safety checks to determine that the 

TV is in safe operating condition.

Choosing a location for your LCD TV

To Display your LCD TV on the included 

Pedestal Stand:

Observe the following safety precautions:

1)  Read and Follow the pedestal assembly instructions 

included with the pedestal.

CAUTION: Before beginning pedestal assembly, 

carefully lay the front of the LCD Panel face down on 

a flat, cushioned surface such as a quilt or blanket. 

Leave the bottom of the unit protruding over the edge 

of the surface and assemble the pedestal as indicated 

below.
Note: 

2)  Place the TV on a sturdy, level surface that can 

support the weight of the TV.

3)  Be sure to secure the TV to a wall, pillar, surface, or 

other immovable structure. ( item 25, page 4).

To Display your LCD TV using a Wall 

Bracket:

If you decide to wall mount your LCD TV, always use 

a UL listed wall bracket appropriate for the size and 

weight of the LCD TV ( page 2):
1)  CAUTION: Two people are required for installation.
2)  Unplug and remove any cables and/or other 

component connectors from the rear of the TV.

3)  Remove the screws of the VESA Mounting Pattern 

show in the next page.

4)  Always use the screws supplied or recommended 

by the wall mount manufacturer.

5)  Follow the instructions provided with your wall 

bracket. Before proceeding, make sure the 

appropriate bracket(s) are attached to the wall and 

the back of the TV as described in the instructions 

provided with the wall bracket. 

6)  After attaching the appropriate bracket(s) to the 

wall and the back of the TV, remove the pedestal 

stand from the TV as described on the following 

page.