Fujitsu P42-2 Manual De Usuario

MYRICA P42-1A / P42-2 / P50-2 

4 - English

 

A26361-K1040-Z120-1-M119, edition 3 

● 

Remove the power plug before cleaning the device. 

● 

Do not clean any interior parts yourself, leave this job to a service technician. 

● 

Do not use any cleaning agents that contain abrasives or may corrode plastic. 

● 

Ensure that no liquid will run into the system. 

● 

Ensure that the ventilation areas of the device are free. 

● 

The display surface of the device is sensitive to pressure and scratches. Clean it only using a 
soft, slightly moistened cloth. 

Wipe the device casing with a dry cloth. If the monitor is particularly dirty, use a cloth which has been 
moistened in mild domestic detergent and then carefully wrung out. 

● 

Transport the device with care and only in its original packaging or another corresponding 
packaging to protect it from knocks and jolts. 

● 

Never drop the device (danger of glass breakage). 

To guarantee safe operation, use the cable supplied. Use the following guidelines if it is necessary to 
replace the original cable set. 
● 

The female/male receptacles of the cord set must meet IEC60320/CEE-22 requirements.  

● 

The cable has to be HAR-certified or VDE-certified. The mark HAR or VDE will appear on the 
outer sheath. 

● 

For devices which are mounted on a desk or table, type SVT or SJT cable sets may be used. 
For devices which sit on the floor, only SJT type cable sets may be used. 

● 

The cable set must be selected according to the rated current for your device. 

 

The shipped version of this device complies with the requirements of the EEC directives 
89/336/EEC "Electromagnetic compatibility" and 73/23/EEC "Low voltage directive".