Maxtor 773W V1.0 Manual De Usuario

3. RE (REFERENCE)

Set the Reference image to which the current screen is compared (from 1-99).
For example, the value 64 would compare the current image to the 64

screen image. The higher value may increase the sensitivity.

4. DET (DETECTION)

The motion detection on each channel can be turned to be

ON or OFF individually.

MOTION

1. SEN (SENSITIVITY)

Sets the sensitivity of the pixel-based Motion Detection feature from 1 to 99.

The highest sensitivity setting is 01, the lowest sensitivity setting is 99.

The default setting is 70.

2. MD-NUM (MOTION DETECTION NUMBER)

Sets the number of targets of the motion detection to occur in order to trigger an Alarm

(from 1-99 target areas).

Note

: MD-NUM cannot be less than the number of targets set in the AREA.

5. AREA

Press the ENTER button on this option to set the Pixel-based
Motion Detection Area for each channel. Red targets represent
where the target is (Figure 1-1). Green targets represent the
Motion Detection Area(Figure 1-2), and Purple targets represent
motion currently taking place (Figure 1-3). After stopping the detection,
the color of target will be green (Figure 1- 4).

To modify the Motion Detection Area, use the following controls:
ZOOM: turn the selected target ON/OFF.

▲▼

◄►: navigates between targets

- : turns all targets on the screen

ON/OFF

+ : turn all targets in the selected row ON/OFF

Note: When the “DET” (DETECTION) setting is “ON”, you must set the motion detection

area or it won’t be triggered.

(MOTION)

SEN MD-NUM RE DET

CAM1      70      03      64    ON     AREA
CAM2      70      03      64    OFF   AREA
CAM3      70      03      64    ON     AREA
CAM4      70      03      64    ON     AREA

MOTION RECORD : ON
DAY START END
DAILY 00 : 00 00 : 00