Maxtor SSA-0412 Manual De Usuario

Set the PTZ camera speed, number, type and ID. 

Select specified channel for motion zone and sensor/alarm setup. 

Select Full Zone or Partial Zone for motion sensing. 

Set the motion sensitivity for the specified channel. 
Control the motion sensitivity from 1 to 9. 

Set the type of sensor for the specified channel. Options are: None, 
N/O (normal open), and N/C (normal closed). 

Select alarm from 1 to 4. 

Set the dwell time of alarm from1 to 60seconds. 

Enable/disable key tone. 

Select an ID of remote control. 
1. Select ID.

 

2. Press the same number as ID set in DVR on a remote controller. 

3. Then 

icon will be displayed on Live screen of DVR that 

respond to the remote control. 

 

 

3-4-1. PTZ Setup 

To control the PTZ functions of the camera, connect the controller to the RS-485 port. 

 

 

Note: For speed dome cameras that support RS-485, connect them directly to the RS-485 port. If the camera 

is controlled with RS-232C, use an RS-485 to RS-232C signal converter. 

 

On the PTZ control Setup screen, you can select or set the protocol type of the camera that is the same as 

the one installed on the site. If the camera has a specific camera ID, select the camera ID using the LEFT 

and RIGHT arrow controls.