Coleman 919A162 Prospecto

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

Coleman

and are registered trademarks of The Coleman Company, Inc.

STITCH LINE

To Set Up Beach Shelter

(continued)

Things You Should Know:

• Under certain conditions (cold weather, high humidity, etc.) condensa-

tion will form on the inside of your Beach Shade. Condensation is caused
by water vapor from your breath, perspiration, or any wet clothing inside
the Beach Shade. It is NOT LEAKAGE through the shelter fabric. It can be
minimized by removing wet clothing from your shelter and by providing
good ventilation through the Beach Shade.

• Never store Beach Shade, even for a short period of time, without drying

it thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your Beach Shade. Use a separate storage bag.

• Stakes should be removed by pulling on the stake itself. Never pull on

the Beach Shade to remove stakes.

• BEACH SHADE POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER

DURING STORAGE.

• Do not leave your Beach Shade set-up for weeks at a time. Be aware that

exposure to ultraviolet rays from the sun can seriously damage material
and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away

from this shelter fabric.

This shelter meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.

To Store

1. All poles and metal stakes must to be placed in the storage

bag to prevent damage to the fabric items placed in the
carry case.

2. Make sure Beach Shade is clean and dry before placing in

carry case.

3. Neatly fold Beach Shade to width of pole storage bag. Place

storage bag on folded Beach Shade, roll tightly, and place in
carry case.

4. Store in a clean, dry area.

03/07

To Secure Beach Shade in Sandy Terrain

1. Fill the (6) sand bags with sand or small rocks. (Fig. 15)
2. Insert the toggle of the filled sandbag through the grommet

on the stake loop where the stake would have been. (Fig. 16)

3. Bury the sand bag to secure the Beach Shade.
4. Tie the end of the guy line to the sand bag, extend and bury.

Repeat for second guy line.

12. Extend guy lines out until

taut then secure with stakes.
(Fig. 10 & 11)

Fig. 10

Fig. 11

Fig. 15

11. Attach guy lines to the front of the Beach Shade, above the

large door, by
inserting the guy
line through the
webbing between
the grommet and
the shade material.
(Fig. 9)

Storage for Small Items

1. Hang the storage bag

on the fabric loops to
keep small items off
the floor. (Fig. 12)

2. Use cord located

above front door of
the Beach Shade as
a dry line.

Fig. 12

Rear Vent Flap

The rear flap of the Beach Shade may be raised and lowered to
allow for better ventilation, improve lighting, or privacy.
1. Unzip inside flap to expose mess screen for ventilation.
2. Roll flap up and

secure by inserting
both dowels through
loops. (Fig. 13)

Fig. 13

Loops &

Dowels

3. Undo outer zipper on rear vent flap and roll up for ventilation

or additional access to Beach Shade.

4. Roll flap up and

secure by inserting
both dowels through
loops. (Fig. 14)

Fig. 14

Loops &

Dowels

Fig. 9

Fig. 16

Front Door Flap

The front door of the Beach Shade may be closed for more
privacy with the zippers .