Coleman 2000001081 Prospecto

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2007 The Coleman Company, Inc.

Coleman

®

and               are registered trademarks of The Coleman Company, Inc.

STITCH LINE

continued

1. All metal poles and stakes must to be placed in the storage

bag to prevent damage to the fabric items placed in the
carry case.

2. Make sure tent is clean and dry before placing in carry case.

3. Remove rainfly, spread out on floor of tent, then unzip 

door & vents before taking tent down for storage.

4. Neatly fold tent to width of pole storage bag, place on tent, 

roll tightly, and place in carry case.

5. Store in a clean, dry area.

11/07

7. Insert one end of each black rainfly 

awning pole into remaining pin in front 
corner of tent (Fig. 5A). Gradually apply
pressure to other end of pole to form 
an arch & insert into other front pin. 
(Fig. 5)

8. Tie guylines through loops on web 

straps on the rainfly. (Fig. 5B)

9. Stretch guylines until taut, then secure

with stakes. (Fig. 5C)

•  Under certain conditions (cold weather, high humidity, etc.) condensa-

tion will form on the inside of your tent. Condensation is caused by 
water vapor from your breath, perspiration, or any wet clothing inside 
the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized 
by removing wet clothing from your tent and by providing good ventila-
tion through the tent.

•  Never store tent, even for a short period of time, without drying it

thoroughly and brushing off caked dirt. Do not pack stakes or poles 
inside your tent. Use a separate storage bag.

•  STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. 

NEVER PULL ON THE TENT TO REMOVE STAKE.

•  TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER

DURING STORAGE.

•  Do not leave your tent set-up for weeks at a time. Be aware that exposure

to ultraviolet rays from the sun can seriously damage material and/or 
cause it to become discolored.

This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.

1. Unzip access panel in the lower

right corner of tent and bring in
electrical cord. Use only UL approved
cords that are rated for outdoor
usage. (Fig. 8)

The smaller zippered opening at the
rear of the tent is designed for added
ventilation and easy access to your
beverage cooler.
1. To use as a vent, unzip flap to 

expose screen. (Fig.6)

2. To use as a cooler access, unzip 

other flap to make an avenue to 
bring beverages into the tent. 
(Fig.7)