Coleman 2000010648 Prospecto
STITCH LINE
SIDEWALL SET UP InSTrUcTIonS
Before You Begin
• Ensure the shelter is set up correctly by carefully reviewing
and following all safety and installation instructions provided
with the shelter.
• The sidewall may be placed in any of the openings of the
Coleman Shelter.
• Shelter should be set at the highest position when used
with sidewall.
2. Stretch sidewall downward
until taut, insert hooks at
the two bottom corners of
sidewall into holes on the
lower part of frame posts.
(Fig. 3)
the two bottom corners of
sidewall into holes on the
lower part of frame posts.
(Fig. 3)
1. Unfold sidewall with the
“Lantern” logo facing
outside. Stretch elastic
straps and hook clips at
the two top corners of
sidewall to the metal rings
on the top of two frame
posts. (Fig.1 & 2)
outside. Stretch elastic
straps and hook clips at
the two top corners of
sidewall to the metal rings
on the top of two frame
posts. (Fig.1 & 2)
3. Locate all hook & loop fasteners on edges of sidewall, then
wrap around frame & frame posts to secure. (Fig. 4 & 5)
4. Stretch webbing loops along
the bottom edge of sidewall,
then secure with stakes.
(Fig. 6)
then secure with stakes.
(Fig. 6)
5. Install the other sidewall following the same way as the sidewall
with “Lantern” logo. (Fig. 7)
Fig. 2
Fig. 3
Fig. 4
Fig. 6
To obtain additional Sidewall units,
see your local retailer or visit
www.coleman.com.
Completed Shelter with sidewall
4010015700 (ECN20020545-01)
The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A.
1-800-835-3278 • www.coleman.com
MADE IN CHINA
© 2011 The Coleman Company, Inc. All rights reserved.
Coleman
®
,
, and are registered trademarks of
The Coleman Company, Inc.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
WARNING: Keep All FlAme ANd heAt souRces AWAy
FRom thIs teNt FAbRIc.
Fig. 1
Disassemble the Sidewall
1. Remove stakes along the bottom edge.
2. Detach hooks at the two bottom corners of sidewall from holes
2. Detach hooks at the two bottom corners of sidewall from holes
on frame posts.
3. Detach all remaining fasteners.
To Store
1. All stakes must be placed in the storage bag to prevent damage
to the fabric items placed in the carry case.
2. Make sure all components are clean and dry before placing in
carry case.
3. Store in a clean, dry area.
Fig. 5
Install the Sidewall
Fig. 7
model 2000010648