Telex XO-AP XO-1 Manual De Usuario
1. On/Off & Volume Control – Turns the beltpack
power on/off and controls headset volume.
2. Battery Light –
•
GREEN - Battery OK
•
RED - Battery Low (needs charged)
3. "O" Channel Button and Light – Selects the
“Offense” intercom channel. The light next to the
button will light when selected. Also controls headset
Mic (-) level:
button will light when selected. Also controls headset
Mic (-) level:
•
Mic (-): press and hold talk button, then press and
hold "O" button. Listen for voice prompts in headset.
Adjust headset mic level lower (-).
hold "O" button. Listen for voice prompts in headset.
Adjust headset mic level lower (-).
4. Talk Button – When pressed the microphone path is
enabled. This button has two operational modes:
•
Momentary – Pressed and hold for over ½ second.
•
Latch on/off – Tap button and the microphone path
is enabled. Tap again to turn off.
is enabled. Tap again to turn off.
5. "X" Button and Light – Selects the “Defense”
intercom channel. The light next to the button will light
when selected. Also controls headset mic (+) level:
when selected. Also controls headset mic (+) level:
•
Mic (+): Press and hold talk button, then press and
hold "X" button. Listen for voice prompts in headset.
Adjust headset mic level higher (+).
hold "X" button. Listen for voice prompts in headset.
Adjust headset mic level higher (+).
6. Charge Jack – Used to charge the internal battery.
Accepts a 5.5mm x 2.5mm plug with the center
positive. Must be supplied with a 12VDC regulated
power supply with at least a 400mA current capacity.
positive. Must be supplied with a 12VDC regulated
power supply with at least a 400mA current capacity.
7. Charge Light.
•
RED = Beltpack battery is charging.
•
GREEN = Beltpack battery is charged.
8. Headset Connector – Standard 4-pin XLR connector.
•
Pin 1 = Microphone GND
•
Pin 2 = Microphone HOT
•
Pin 3 = Headphone +
•
Pin 4 = Headphone –
9. Programming Jack – This RJ-45 jack is used for
programming the unit at the factory. It can also be used
for changing the user’s password and encryption code.
for changing the user’s password and encryption code.
Section 3 - XO-1 Beltpack
Controls and Connections
Telex
R
MIC
OFF
BATTERY
TALK
MIC +
X
O
1
2 3 4
5
3-1
CHG
EXT
6
7
8
9
Top View
Bottom View