Samsung 15-1634 Manual De Usuario

3

and seal the connection with coax 
sealant tape or a weather boot.

4. Mount the antenna on the mast, and 

secure it by tightening the hex nuts 
evenly onto the U-bolts.

.

+)*60+0)

"2

416'%6+10

• Ground wires for both the mast and 

downlead should be copper or aluminum 
wire, 8 AWG or larger.

• Mount a grounding block (not supplied, 

available at RadioShack) as close as 
possible to where the downlead enters 
the house.

• Downlead wire from the antenna to the 

grounding block and the mast ground 
wire should be secured to the house with 
stand-off insulators, spaced 4–6 feet 
apart.

%100'%6+0)"6*'"#06'00#"61";174"68

1. Connect the coax downlead from the 

antenna to the 

 jack on the power 

injector.

2.

If your TV has an F-connector, connect 
the short piece of coax from the power 
injector to your TV’s VHF/UHF 75-ohm 
F-connector.

If your TV has screw terminals for VHF/
UHF connection, connect a 75-to-300 
ohm transformer (not supplied, available 
at RadioShack) between the power 
injector and the VHF/UHF terminals.

If your TV has a 75-ohm VHF connection 
and a 300-ohm UHF connection, 
connect a signal splitter (not supplied, 
available at RadioShack) between the 

power injector and the TV’s VHF/UHF 
connections.

3. Insert the supplied AC adapter’s small 

plug into the power injector’s 

 

jack. Plug the adapter into a standard 
AC outlet. The power injector’s indicator 
lights to indicate that the antenna is 
properly connected.