Vision Fitness R2000 Manual De Usuario

• Attach the rear support to the seat rail
with four screws (M8x15) and four lock
washers (M8). Tighten with the 5mm 
T-shaped wrench.

• Slide the seat frame onto the seat
rail. Make sure the flat side of the
clamp block rests against the bottom
of the seat rail.

• Insert the heart rate wires located
under the seat frame through the hole
on the bottom of the seat rail and push
them toward the front of the rail.  Take
the end of the heart rate wires that
runs through the seat rail and insert
them through the hole in the bracket at
the end of the rail.  Snap the wire grip
around the end of the heart rate wires
and slide it into place on the bracket.

• Attach the rubber stopper to the bot-
tom of the seat rail with the (M5x10)
screw.