Vision Fitness R2200 Manual De Usuario

• Slide the console mast cover onto
the console mast.

• Use the wire tie coming from the bot-
tom of the console mast to wrap around
the wire harness and heart rate wires
that are sitting in the frame bracket.

• Pull the wire tie up through the con-
sole mast so the wire harness and heart
rate wires exit the top of the mast.

• Slide the bottom of the console mast
into the frame bracket. Use the 5mm
allen wrench to secure the four screws
(M8x15) and four lock washers (M8)
to the sides of the console mast brack-
et. Use the 5mm L-shaped wrench to
secure the last screw (M8x15) to the
edge of the bracket facing the seat.
Tighten only until snug.

• Mount the console mast handlebar
to the console mast with two screws
(M8X20) and two lock washers (M8).
Tighten with the 5mm allen wrench.

• With a screwdriver remove the four
mounting screws from the backside of
the console. Connect the heart rate
wires and the wire harness to the pin
connectors on the backside of the con-
sole. Mount the console to the console
mast using the four mounting screws
and the screwdriver.

• Slide the console mast cover into place
so it integrates with the side covers.

• Mount the water bottle cage to the
console mast with the screws located
on the console mast.