Samsung CLX-6240FX Manual De Usuario

Getting started_ 25

getting started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:
•

•

•

•

•

•

This section shows the steps to set up the hardware which is explained in 

the Quick Install Guide. Make sure you read Quick Install Guide and 

complete following steps.
1. Select a stable location. 

Select a level, stable place with adequate space for air circulation. Allow 

extra space to open covers and trays. 

The area should be well-ventilated and away from direct sunlight or 

sources of heat, cold, and humidity. Do not set the machine close to the 

edge of your desk or table.

 

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the 

altitude setting to optimize your printing. See "Altitude adjustment" on 

page 28 for more information.
Place the machine on a flat, stable surface so that there is no incline 

greater than 2 mm (0.08 inch). Otherwise, printing quality may be 

affected. 

2. Unpack the machine and check all the enclosed items.
3. Remove the tape holding the machine tightly.
4. Install the toner cartridge.
5. Load paper. (See "Loading paper" on page 36.)
6. Make sure that all the cables are connected to the machine. 
7. Turn the machine on. 

Print a demo page to make sure that the machine is operating correctly.

To print a demo page:

In ready mode, press and hold the OK button for about 2 seconds.

You need to set up the network protocols on the machine to use it as your 

network printer. You can set up the basic network settings through the 

machine's control panel.

The following table shows the network environments supported by the 

machine:

When you move the machine, do not tilt or turn it upside down. 

Otherwise, the inside of the machine may be contaminated by toner, 

which can cause damage to the machine or bad print quality.

•

Ethernet 10/100 Base-TX

•

IEEE 802.11 b/g Wireless LAN 

(optional)

•

Windows 2000/XP/2003/Vista

•

Various Linux OS

•

Mac OS X 10.3 ~ 10.5

•

TCP/IP on Windows 

•

IPP

•

SNMP

•

DHCP

•

BOOTP

If you want to set up DHCP network protocol, go to 

http://

, select the 

Bonjour program that is appropriate for your computer operating 

system and install the program. This program will allow you to set 

network parameters automatically. Follow the instructions in the 

installation window. This program does not support Linux.