Avaya 1150E Manual De Usuario
Connecting the components
41
Method A: Press the wall-mount lever, and pull the phone away from
the stand as shown in
the stand as shown in
.
Using the stand cover (the part you removed in step 1), mark the wall-
mount holes by pressing the bottom of the stand cover firmly against
the wall in the location where you want to install the phone. Four
small pins on the bottom of the stand cover make marks on the wall.
Use the marks as a guideline for installing the wall-mount screws (not
provided). Install the screws so that they protrude 3 mm (1/8 inch)
from the wall, and then install the phone stand mounting holes over
the screw heads as indicated in
mount holes by pressing the bottom of the stand cover firmly against
the wall in the location where you want to install the phone. Four
small pins on the bottom of the stand cover make marks on the wall.
Use the marks as a guideline for installing the wall-mount screws (not
provided). Install the screws so that they protrude 3 mm (1/8 inch)
from the wall, and then install the phone stand mounting holes over
the screw heads as indicated in
(Method A). You
may need to remove the phone from the wall to adjust the lower
screws. When the lower screws are snug, install the phone on the
mounting screws, and then tighten the top screws.
screws. When the lower screws are snug, install the phone on the
mounting screws, and then tighten the top screws.
Method B: Attach the 15-cm (6-inch) CAT5e cable, position the stand
over the mounting rivets, and slide the phone down the wall so that
the rivets fit into the slots on the stand, indicated in
over the mounting rivets, and slide the phone down the wall so that
the rivets fit into the slots on the stand, indicated in
(Method B).
8.
Replace the stand cover. Ensure that all cables are neatly routed and
press the stand cover into place until you hear a click.
press the stand cover into place until you hear a click.
9.
Put the phone in the wall-mount position (optional). If you wall-
mounted your phone, put it in the wall-mount position by holding the
Tilt lever and pressing the phone towards the base until the phone is
parallel with the base. Release the Tilt lever and continue to push the
phone towards the base until you hear an audible click. Ensure the
phone is securely locked in position.
mounted your phone, put it in the wall-mount position by holding the
Tilt lever and pressing the phone towards the base until the phone is
parallel with the base. Release the Tilt lever and continue to push the
phone towards the base until you hear an audible click. Ensure the
phone is securely locked in position.