Cisco Systems VG204 Manual De Usuario
1-6
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 1 Understanding Interface Numbering and Cisco IOS Software Basics
Typical Voice Gateway Deployment Scenario
It might take a minute or two to save the configuration to NVRAM. After the configuration has been
saved, the following appears:
saved, the following appears:
[OK]
VG#
Upgrading to a New Cisco IOS Release
To install or upgrade to a new Cisco IOS release, see
in the
Note
To simplify network operations and management of Cisco IOS software migration, see the
.
Typical Voice Gateway Deployment Scenario
shows a typical deployment scenario for a Cisco VG202, Cisco VG202XM, Cisco VG204, or
Cisco VG204XM voice gateway.
Figure 1-3
Analog FXS User Interfaces
Where to Go Next
Now that you have learned some Cisco IOS software basics and seen a typical deployment scenario, you
can begin to configure your voice gateway by using the CLI.
can begin to configure your voice gateway by using the CLI.
Remember that:
•
You can use the question mark (?) and arrow keys to help you enter commands.
•
Each command mode restricts you to a set of commands. If you have difficulty entering a command,
check the prompt and then enter the question mark (?) for a list of available commands. You might
be in the wrong command mode or be using the wrong syntax.
check the prompt and then enter the question mark (?) for a list of available commands. You might
be in the wrong command mode or be using the wrong syntax.
1
Ethernet
2
Cisco VG204/Cisco VG204XM voice
gateway
gateway
3
RJ-11 cables
4
Analog telephones
272489
2
1
3
4