Cisco Systems 8851 Manual De Usuario
When more than one KEM is attached to the Cisco IP Phone 8861, the fast-charge feature using the back
USB port is not supported. In this scenario, the back port will slow-charge the device.
USB port is not supported. In this scenario, the back port will slow-charge the device.
Note
Connect Single KEM to Cisco IP Phone
Procedure
Step 1
Unplug the Ethernet cable from the phone.
Step 2
If installed, remove the footstand from the phone.
Step 3
Locate the accessory connector covers on the side of the phone.
The following diagram shows the location of the accessory connector covers.
The following diagram shows the location of the accessory connector covers.
Step 4
Remove the two accessory connector covers.
The following diagram shows the removal of an accessory connector cover.
The following diagram shows the removal of an accessory connector cover.
Cisco IP Phone 8811, 8841, 8851, and 8861 Administration Guide for Cisco Unified Communications Manager 10.5
95
Connect Single KEM to Cisco IP Phone