Cisco Systems 8851 Manual De Usuario
Before You Begin
You require 2 metal rods.
Procedure
Step 1
Push the rods into the left and right holes in the phone mounting plate approximately 0.75 in (2.0 cm).
Step 2
Press firmly inwards (towards the phone) to disengage the tabs, lift up on the phone to release the phone from
the wall bracket, and then pull the phone towards you.
the wall bracket, and then pull the phone towards you.
Figure 9: Disengage Tabs
Step 3
Press firmly to disengage the tabs and lift the phone at the same time to release the phone from the wall bracket.
Non-Lockable Wall Mount Components for Phone with Key Expansion Module
This section describes how to install the Cisco IP Phone 8800 Series Wall Mount Kit with Single KEM on a
phone when the phone is connected to a Key Expansion Module.
phone when the phone is connected to a Key Expansion Module.
The following figure shows the wall mount kit installed on the phone.
Cisco IP Phone 8811, 8841, 8851, and 8861 Administration Guide for Cisco Unified Communications Manager
10.5
116
Non-Lockable Wall Mount Components for Phone with Key Expansion Module