Panasonic KX-TG2970 Manual De Usuario

If the display shows error messages, see “If the Following Appear on Your 
Display...” (p. 70–72) for the Cause & Remedy.

“No link to base.
Walk closer to
base and try
again.” is displayed and an 
alarm tone sounds.

• The cordless handset has lost 

communication with the base unit. Walk 
closer to the base unit, and try again.

• Confirm the base unit’s AC adaptor is 

plugged in.

• Raise the base unit antennas.
• The cordless handset’s registration may have 

been canceled. Re-register the cordless 
handset (p. 68, 69).

Static, sound cuts in/out, 
fades. Interference from other 
electrical units.

• Move the cordless handset and the base unit 

away from other electrical appliances (p. 3).

• Walk closer to the base unit.
• Raise the base unit antennas.
• Press [ ] on the cordless handset to turn on 

the Clarity Booster feature (p. 31).

• If the unit is connected to a telephone line 

with DSL service, you may hear noise from 
the receiver or speaker during conversations. 
We recommend connecting a noise filter 
(contact your DSL service provider) to the 
telephone line between the base unit and the 
telephone line jack.

The base unit and/or cordless 
handset does not ring.

• The ringer volume is turned off. Set to HIGH, 

MEDIUM or LOW (p. 21).

• If more than one other unit is in use, the 

cordless handset/base unit may not ring. 
Users will hear incoming call tones (p. 52).

The cordless handset display   
is blank.

• If only the cordless handset display is blank, 

fully charge the battery (p. 12).

You cannot program any 
function items.

• Programming is not possible while the unit is 

being used.

• Do not pause for over 60 seconds while 

programming.

• Walk closer to the base unit if you are using 

the cordless handset.

• While another user is listening to messages 

or the Answering System is responding to a 
call, you cannot program. Try again later.

TG2970.book  Page 73  Friday, October 15, 2004  6:21 PM