Panasonic KX-TS3282W Manual De Usuario
46
A 2-way intercom can be set up between two extensions.
Make sure that each extension has been assigned the number ([1] to [8])
(p. 17) and is connected to the LINE1/2 telephone jack of the unit (p. 11-13).
Make sure that each extension has been assigned the number ([1] to [8])
(p. 17) and is connected to the LINE1/2 telephone jack of the unit (p. 11-13).
Paging a Designated Extension
1
Press [INTERCOM].
• The INTERCOM indicator lights.
• The SP-PHONE/HEADSET indicator
• The SP-PHONE/HEADSET indicator
lights and the speakerphone turns on.
• To switch from the speakerphone to the
handset, lift it off the cradle.
2
Press an extension button ([EXT1] to
[EXT8]).
[EXT8]).
• A long beep is heard if the ringer pattern of
the paged extension is a ringer tone (p. 23).
*
3
After the paged extension answers, talk
into the MIC (microphone) or handset.
into the MIC (microphone) or handset.
• The display shows the length of the call.
4
To end the intercom, press [SP-PHONE/HEADSET] or place the
handset on the cradle.
handset on the cradle.
• The INTERCOM and SP-PHONE/HEADSET indicator lights go out.
*
If 2 short beeps are heard in step 2, the ringer pattern of the paged extension is
the Voice mode, the Auto Answer mode or the Room Monitor mode. Speak into
the MIC or handset to page the extension for the Voice or Auto Answer mode.
the Voice mode, the Auto Answer mode or the Room Monitor mode. Speak into
the MIC or handset to page the extension for the Voice or Auto Answer mode.
• If the destination extension is the Auto Answer or Room Monitor mode, “
Calling
”
with the extension number will not be displayed on your unit.
During an intercom call:
• To adjust the handset or speaker volume, press VOLUME [ ] or [ ] (p. 26).
• If the other extensions are busy with intercom or page, you will hear a busy tone
• If the other extensions are busy with intercom or page, you will hear a busy tone
and “
Busy
” will be displayed when you press [INTERCOM]. Wait until the
INTERCOM indicator light goes out.
• You can place the intercom call on hold by pressing [HOLD]. To release the
hold, press [INTERCOM].
• If an incoming call is being received, you will hear two tones (incoming call
tone, p. 54) and the line indicator will flash quickly. To answer the call, press the
called line button.
called line button.
• You can switch from the speakerphone to the handset by lifting it off the cradle.
To switch back to the speakerphone, press [SP-PHONE/HEADSET]. You can
place the handset on the cradle.
place the handset on the cradle.
Intercom
Press EXT1~EXT8
or PAGE
Ex. Calling EXT. 2
Intercom
Calling [2]
Ex. Intercom with EXT. 2
Intercom [1]-[2]
00-00-00
>
<
Intercom