Panasonic KX-TG7341NZ Manual De Usuario

Descargar
Página de 52
Programming
26
Selecting area codes to be 
deleted automatically
In some situations, phone numbers 
stored automatically in the caller list 
(page 29) will include area codes. If you 
do not want to dial the area codes when 
making calls from the caller list, you can 
store the area codes which you want the 
unit to delete automatically.
Example: You have stored the area 
code “09”. If you make a call from the 
caller list to the phone number “09-456-
7890”, the unit dials “456-7890”.
1
K
 (middle soft key)
2
{V}
/{^}: “Base Unit Setup” i 
M
3
{V}
/{^}: “Area Code” i M
4
Enter an area code (5 digits max.). 
i
 M i {ih}
Note:
L
The use of this feature can prevent a 
National Call from being dialled. E.g., 
in the case of the South Island, the 
“03” will be omitted and will therefore 
prevent a National Call to other areas 
of the South Island.
Changing the base unit PIN 
(Personal Identification 
Number)
Important:
L
If you change the PIN, please make 
note of your new PIN. The unit will not 
reveal the PIN to you. If you forget 
your PIN, contact your nearest 
Panasonic service centre.
1
K
 (middle soft key)
2
{V}
/{^}: “Base Unit Setup” i 
M
3
{V}
/{^}: “Base Unit PIN” i 
M
4
Enter the current 4-digit base unit 
PIN (default: “0000”).
5
Enter the new 4-digit base unit PIN. 
i
 M i {ih}
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to 
the base unit.
Important:
L
The additional handset model 
recommended for use with this unit is 
noted on page 4. If another handset 
model is used, certain operations 
(handset settings, base unit settings, 
etc.) may not be available.
Registering a handset to the 
base unit
The supplied handset and base unit are 
pre-registered. If for some reason the 
handset is not registered to the base unit 
(for example, w flashes even when the 
handset is near the base unit), re-
register the handset.
1
Handset:
K
 (middle soft key)
2
{V}
/{^}: “Handset Setup” i 
M
3
{V}
/{^}: “Register H.set” i 
M
4
Base unit:
Press and hold {x} for about 5 
seconds, until the registration tone 
sounds.
L
If all registered handsets start 
ringing, press the same button to 
stop. Then repeat this step.
TG7341NZ(e).book  Page 26  Wednesday, September 3, 2008  11:37 AM