Panasonic KX-TG1313NZ Manual De Usuario
Preparation
8
Note:
L
L
It is normal for batteries not to reach full capacity at the initial charge.
Maximum battery performance is reached after a few complete cycles of
charge/discharge (use).
Maximum battery performance is reached after a few complete cycles of
charge/discharge (use).
L
Actual battery performance depends on a combination of how often the
handset is in use and how often it is not in use (standby).
handset is in use and how often it is not in use (standby).
L
Even after the handset is fully charged, the handset can be left on the
base unit or charger without any ill effect on the batteries.
base unit or charger without any ill effect on the batteries.
L
The battery level may not be displayed correctly after you replace the
batteries. In this case, place the handset on the base unit or charger and
let it charge for at least 7 hours.
batteries. In this case, place the handset on the base unit or charger and
let it charge for at least 7 hours.
Controls
Handset
A Receiver
B Display
C {k} (Phonebook)
D {C} (Talk)
E Navigator
B Display
C {k} (Phonebook)
D {C} (Talk)
E Navigator
({e}/{v}/{>}/{<})
?
?
(Volume: {e}/{v})
F {R} (Redial/Pause)
G {R} (Recall/Flash)
H Microphone
I {j/OK} (Menu/OK)
J {ih} (Off/Power)
K {C} (Clear)
L {INT}
G {R} (Recall/Flash)
H Microphone
I {j/OK} (Menu/OK)
J {ih} (Off/Power)
K {C} (Clear)
L {INT}
KX-TG1311:
To stop paging
KX-TG1312/KX-TG1313:
To stop paging/Intercom
To stop paging
KX-TG1312/KX-TG1313:
To stop paging/Intercom
M Charge contacts
N Ringer
N Ringer
N
A
B
C
C
K
L
M
J
D
E
F
E
F
G
H
I
TG1311_1312_1313NZ(e).book Page 8 Tuesday, September 16, 2008 4:28 PM