Panasonic KX-TG1312NZ Manual De Usuario

22

Caution:
L

To avoid permanent damage, do not use a microwave oven to speed up 
the drying process.

{j

/OK}

{v}

/{e}: “SETTING HS” i {>}

{v}

/{e}: “REGISTRATION” i {>}

{v}

/{e}: “REGISTER HS” i {>}

Press and hold {x} on the base unit for about 5 seconds.
L

If all registered handsets start ringing, press {x} to stop, then start 
again from step 1.

L

The rest of the procedure must be completed within 4 minutes.

{v}

/{e}: Select a base unit number. i {>}

Wait until “BS PIN” is displayed. i Enter the base unit PIN (default: 
“0000”). i {>}

L

If you forget your PIN, contact your nearest Panasonic service centre.

L

When the handset has been registered successfully, w stops 
flashing.

L

If w is still flashing, start again from step 1.

■ Number of channels: 120 Duplex Channels
■ Frequency range: 1.88 GHz to 1.90 GHz
■ Duplex procedure:

TDMA (Time Division Multiple Access)

■ Channel spacing: 1,728 kHz
■ Bit rate: 1,152 kbit/s
■ Modulation:

GFSK (Gaussian Frequency Shift Keying)

■ RF transmission power:

Approx. 10 mW (average power per channel)

■ Voice coding: ADPCM 32 kbit/s
■ Power source: 220–240 V AC, 50/60 Hz
■ Power consumption:

Base unit:
Standby: Approx. 1.2 W
Maximum: Approx. 3.9 W
Charger

Standby: Approx. 0.6 W
Maximum: Approx. 3.6 W

■ Operating conditions:

5 °C–40 °C, 20 %–80 % relative air humidity (dry)

Liquid or other form of 
moisture has entered the 
handset/base unit.

L

Disconnect the AC adaptor and 
telephone line cord from the base unit. 
Remove the batteries from the handset 
and leave to dry for at least 3 days. 
After the handset/base unit are 
completely dry, reconnect the AC 
adaptor and telephone line cord. Insert 
the batteries and charge fully before 
use. If the unit does not work properly, 
contact your nearest Panasonic service 
centre.

TG1311_1312_1313NZ(e).book  Page 22  Tuesday, September 16, 2008  4:28 PM